When establishing DHCPv6 on EdgeRouter, I can run the a configuration instructions like the next:
set dhcpv6-pd pd 0 interface eth1 prefix-id :0
set dhcpv6-pd pd 0 interface eth2 prefix-id :1
This leads to the interfaces having totally different IPs:
2601:xxx:xxxx:7450::1/64
2601:xxx:xxxx:7451::1/64
I’m struggling to know what the pd 0 portion of the command controls, and I’m unable to seek out any documentation about these instructions to assist my understanding, and I am not super-familiar with IPv6 to fill within the gaps. I do know that if the CIDR block is just too small, you can’t create extra pds, however I am confused how this all ties collectively.
I am aware of IPv4 and subnetting/CIDR, and I am confused as a result of it seems IPv6 additionally helps subnetting/CIDR, however on high of that has a secondary ‘block’ kind (prefix-id) and doubtlessly a tertiary (pd)?!
Moreover, I believed that a part of IPv6 was its means to delegate IPs offered in a block to machines in your community, so I am attempting to know the distinction in setup between that, and a typical NAT/masquerade of a single WAN tackle from a separate subnet in your community (ie: ISP Provides you IP 1.1.1.1 and you utilize 192.168.1.0/24 in your community).
- What’s PD vs Prefix ID?
- How do PD and Prefix ID slot in with CIDR and understanding of IPv4 CIDR
- Does PD must do with delegation of extra IPs in a offered block or is it unrelated?
- Why does my eth0 IPv6 IP differ drastically than the IPs being handed out to the LAN? (ie: eth0 2001:…/128). I might count on this to be the primary tackle on the block, and the LAN machines take the extra addresses on the identical block, however this does not appear to be the case.